Ariana layout #3

Today I have a two page layout that I made from ideas in the current CTMH Idea Book. One was pictured in a wooden frame and the other was shown using the chipboard Bracket Frame. I made them into flat regular layouts.

The left page is very detailed. It has machine stitching, making a strip that looks pleated but isn't, 3D embellishments, spray pen splattering with re-inkers and pearl paint, stamping, the Black & Grey assortment of Epoxy Bubbles and using Dimensional Elements.

To start with I mixed up two Spray Pens with re-inker and pearl paint. One was a Outdoor Denim Re-inker and the other was Black. Adding the pearl paint gives it a nice shimmer when it is sprayed on the page. This was done to both base pages first. Then after that had a good chance to dry (very important or it will smear as you do the machine stitching.) I did the machine stitching all around the base page 3/8" in using white thread. Now set this aside.

The strip that appears to be pleated was a group of 3/4" x 3" strips of Ariana B&T. I inked the edges with Whisper ink and then added strip after strip attaching only in the center so I could sew across the top and bottom. I used the white thread again and the 3/8" seam across the top edge and the bottom edge.

The strip alongside the photo was stamped with Sorbet ink and cut out. A stamped flower was added with the D.E. flowers which added more dimension. It was a fun layout to make.

 
The right page has the spray pen splattering , stitching, and stamping also.  It is a little bit subdued because the left page was so full.  Another fun layout to make.

This one has a couple of Cricut cuts using the CTMH cartridges too.

I hope you enjoy.

Thanks for stopping by.